Get premium quality cable management systems directly from the manufacturer.
Fill out the form below to receive our catalog and pricing.
Cable tray wall brackets support routes that run alongside a wall, structural frame, service corridor, or equipment line. A bracket is not simply a piece of bent steel selected by tray width. The wall substrate, anchorage type, tray system geometry,…
Cable tray grounding and bonding must be designed as part of the project’s electrical safety system. A metallic tray section, splice plate, divider, cover, or support bracket should not be assumed to provide a required electrical path simply because the…
Cable tray expansion joints allow a tray assembly to accommodate movement that may arise from temperature change, long continuous runs, building movement, or a structural expansion location. They are not a generic accessory to be added at a fixed interval…
Cable tray covers protect a routed cable system only when their shape, jointing, fixing, material, and maintenance access match the actual route conditions. The practical choices are solid covers, ventilated covers, and peaked covers. Each form addresses a different exposure…
Electrical cable tray components work as one support system. The tray section, side rails, rungs, fittings, splice plates, covers, supports, clamps, and bonding hardware all need compatible dimensions and finishes. A tray order that specifies only width and material often…
Seismic bracing failures in MEP systems rarely trace back to a single bad part. They trace back to a selection process that treated bracing as a generic hardware add-on rather than a coordinated restraint assembly sized to a specific load…
Learn how to specify, install, and inspect seismic bracing for MEP pipe, duct, and cable tray routes in industrial and commercial projects.
Learn how to design, specify, install, and inspect seismic bracing for cable tray routes in industrial, data center, and MEP projects.
What Is Cable Tray Support Distance? Cable tray support distance is the center-to-center spacing between supports that a tray spans under a stated load, typically about 1.5 m to 3.0 m for standard systems. For buyers and specifiers, that number…
Cable tray clips are small retention components used in cable management systems to secure covers, dividers, bonding parts, accessories, or, in some cases, cables to a cable tray or cable ladder. They do not usually carry the primary tray load.…